Other

The Funky Monkey is a simple, hanging housing stop for front and rear center pull and cantilever brakes. This simple part is brought to a whole new level with our renowned machining prowess. - Cable stop for front centerpull and cantilever brakes - Integrated barrel adjuster for cable tension. 26G - Made in USA Clamp Diameter: 1-1/8-inch

The ultimate fancy straddle wire holder - Integrated cable clamp & 8mm hex so you can put a wrench on it - Moon Units come as a set of 2

Mounted in place of a front derailleur, the Chain Keeper works with single and 1x multi speed drivetrains using a narrow chain. The chain block surrounds the chain as it meets the chainring and prevents it from skipping off. - Accommodates a range of chain line measurements and chainring sizes - Not designed for downhill/freeride/big hit use

Paul Components Melvin Chain Tensioner. Converts frames for single speed use. Long enough for a Dingle-setup, (2 rings, one cog) 20T max. - The Melvin uses two pulleys, just like a rear derailleur, which gives it 20 teeth of chain wrap - Will work with multiple front chain rings while maintaining proper chain tension - The pulleys are made of extruded and machined aluminum and have sealed bearings for durability - Pulleys are 2.25mm thick at the tooth which fits inside most narrow 6 through 9 speed chains, and the pulley cage is wide enough to allow 1/8? single speed chains as well - Long enough for a Dingle-setup, (2 rings, one cog) 20T max - Do not use with a coaster brake or fixed gear - Includes Paul's own Sealed Bearing Pulleys

A pair of anodized Spring nuts for use with any Paul Component rim brakes. - Replacement spring adjusters to fit any Paul rim brake - Machined in the USA of 6061 Aluminum - Sold per brake

Replacement parts for Paul rim brakes.

Paul's dropper trigger with stacked dual sealed cartridge bearings, two different cable clamp options, a barrel adjuster, and a hinged clamp. - Dual stacked sealed cartridge bearings in the pivot for zero slop and long (serviceable) life - Pinch bolt and cable head recess allowing you to run the cable in either direction - Hinged clamp so you can install it without removing the grip - Barrel adjuster for fine tuning the cable tension

Paul's dropper trigger with stacked dual sealed cartridge bearings, two different cable clamp options, a barrel adjuster, and a hinged clamp. - Dual stacked sealed cartridge bearings in the pivot for zero slop and long (serviceable) life - Pinch bolt and cable head recess allowing you to run the cable in either direction - Hinged clamp so you can install it without removing the grip - Barrel adjuster for fine tuning the cable tension